Hi Bryan!
Zitat von
Bryan Whitby
Now how to make a capture using the SolusChess board.
Say I play against the Fidelity Designer 2325, to capture a piece only takes two presses of the board as the destination square automatically removes the captured piece.
If however I play against the Fidelity AG v10, to capture a piece takes three presses because the destination square doesn't automatically remove the captured piece.
It works exactly the same as using a mouse.
Hmm? Now you are confusing me!?
From what I've seen on the Internet this SolusChess board is a
magnetic (but not a pressure) sensor board, so you don't need to 'press' any square, but just take away a piece from or put it down to any square.
And usually a magnetic sensor board sends a signal for both events (lifting a piece or putting it down). So if the Solus board sends a keycode for both events, then CB-Emu will be just as confused by capture moves as I am now by your explanation.
Maybe a simpler question would explain, what exactly the Solus board is doing:
If you simply lift a piece from a square (on your board), does then the corresponding piece on the CB-Emu screen become marked (grey/highlighted)?
Regards,
CBF